A mis-triggered row cannot be written as it arrived — v6 declares n_frames per
row in the header and has no per-row length field, so a short or long row
would shift every later row in the file. Until now the only policy was to
square it up, which keeps the scan running but leaves the affected row
indistinguishable from a good one afterwards: nothing in the file records that
it was padded.
strict_rows selects the other trade. On any frame-count mismatch the scan
stops instead of writing the row, so a data run either produces rows that mean
what the header says they mean or fails loudly. Default stays pad, so existing
behaviour is unchanged.
_warn_frame_delta becomes _check_frame_delta, since it now decides rather than
just reports. Both acquisition paths already call it before writing anything
for the row (CH1 leads SCAN_CHANNELS, and the burst path checks every row up
front), so an abort leaves the file on a whole-row boundary rather than a
half-written row — test_strict_row_packing_writes_nothing_for_the_failed_row
pins that.
Plumbed through QtScanController to a checkbox in the scan panel, persisted in
ScanDefaults alongside burst_mode. scan_format.md documents both policies and
notes that the choice is not recorded in the file.
The row-clipping setup in the padding test is now a _clip_one_row helper,
reused by the strict tests. 92 tests passing, ruff clean.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Wires the burst_mode flag through QtScanController to ScanEngine and adds a
checkbox to the scan panel. The setting persists via ScanDefaults like the
other scan fields, defaulting to off — per-row acquisition stays the default
path until burst mode has run on the rig and the gate-off preflight has
settled which TRIGOUT value idles the pin low.
scan_format.md — the acquisition settings table had drifted from the code it
claimed to describe: it attributed the settings to sc3_aui_app.py (they moved
to core/scope_sras.py in the Phase 2 extraction), listed a 1.24 V trigger
level and 0 % offset where the code sets 0.500 V and HORizontal:POSition 30,
and did not mention the logic-AND scan trigger at all. Corrected, pointed at
the module that actually owns them, and noted that none of it affects byte
layout — only where the acoustic packet lands inside a frame.
Added an acquisition-paths section: the two paths write byte-identical files
and the choice is a runtime flag that is not recorded in the file, so a
reader never needs to care which produced it. Documents where row boundaries
come from in a burst and that either path squares rows up to n_frames.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Thomas Ales