Groundwork for burst acquisition: the scope needs to report and transfer a
whole multi-row FastFrame acquisition, and the BBD needs to gate its trigger
output per row rather than staying armed for the scan.
tektronix_base
- get_fastframe_max_frames() exposes HORizontal:FASTframe:MAXFRames?, which
is what sizes a burst once the horizontal settings are fixed.
- transfer_fastframe_bulk() pulls a burst as one contiguous buffer. Unlike
transfer_fastframe it does not assume how the scope frames the response:
it accumulates until the expected byte count is reached, so one large IEEE
block and one block per frame both work.
- set_data_encoding() / set_data_width() make the transfer format settable
instead of inherited from whatever the front panel was left on.
- read_raw() had two real defects. The length-digit read used a bare recv()
and only checked the length afterwards, so a short read raised "Failed to
read data length" on a perfectly good transfer; it now goes through a
_recv_exact() helper, as does the trailing separator. And a #0
indeterminate-length block was parsed as int("") -> ValueError. #0 is
normally delimited by EOI, which a raw socket never sees, so read_raw now
takes expected_bytes to size it. The bulk transfer relies on this.
pybbd202
- arm_scan_gate(axis, armed) raises and drops the max-velocity trigger
output the scope's AND-gate uses. A burst spans several rows with the
scope running throughout, so the gate must be low for the flyback or the
return move reaches max velocity and injects frames between rows.
- set_trigger_verified() reads the mode back after setting it. set_trigger
is fire-and-forget over the shared TX queue; burst mode toggles the gate
between every row, where a dropped change silently corrupts the file
rather than failing loudly.
- set_trigger_gate_off() so the scan can leave the output idle on exit.
- TRIGOUT_GATE_OFF is deliberately marked unverified. §7.6 of the BBD203
protocol doc describes `mode` as an enumeration capping at 0x11, which
contradicts the bitmask this driver actually sends (TRIGOUT_MAXV = 0x90,
known working), so the doc cannot settle which value idles the pin low.
The engine's preflight check resolves it on the rig instead.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
- uc480_camera: drop never-called _capture_paused/get_framerate (the
hardware question _capture_paused encoded is now in KNOWN_ISSUES.md)
- t3r_protocol: drop read_reg/write_reg/decode_reg/Reg (commands never
wired into the driver)
- bbd20x: drop _update0x0212 (never dispatched) and 8 of 9 unused
trigger convenience wrappers; apt_constants: drop TriggerBitsStepper
(servo-only rig)
- ruff --fix: 35 unused imports across all apps; drop unused T3R_BAUD
- genesis_core.py: quarantine warning header; docs/genesis_verification.md
bench checklist for the 7 divergences vs tools/genesis_laser_gui.py
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Thomas Ales